Differences

This shows you the differences between two versions of the page.

--- aeromodelismo:jawbreakerdrone [2019/03/02 12:39] – [Parts] rlunaro
+++ aeromodelismo:jawbreakerdrone [2019/10/26 22:22] – rlunaro
@@ Line 18: / Line 18: @@
 [[https://hobbyking.com/es_es/tbs-triumph-sma-2pcs.html|Antennae]]
-[[https://hobbyking.com/en_us/panda-rc-vt5804m-v2-5-8ghz-fpv-switchable-48ch-vtx-0-600mw-7-24v.html|FPV transmitter]]
+[[https://hobbyking.com/en_us/panda-rc-vt5804m-v2-5-8ghz-fpv-switchable-48ch-vtx-0-600mw-7-24v.html|FPV transmitter]] {{ :aeromodelismo:pandavt5804m_transmission_specifications.pdf |transmission specifications}} {{ :aeromodelismo:pandaled_flow_chart.jpg?linkonly |flow chart}}
 [[http://www.banggood.com/1PCS-PandaRC-MMCX-to-SMARP-SMA-Female-Adapter-Connector-Cable-70mm-p-1184377.html?rmmds=cart_middle_products|antennae adapter cable]]
+[[#|Receiver: Frsky XSR]] [[https://www.frsky-rc.com/wp-content/uploads/Downloads/Manual/XSR-Manual.pdf|manual here]] {{ :aeromodelismo:xsr-manual.pdf |and here}}. Obviously, this is only if your transmitter is FRSKY.
+===== Lux racer =====
+For the firmware update and configuration, I've tried the zadig drivers that describes the manual of the
+board, but I didn't achieve a good configuration. It appears "error connecting serial port".
+Searching on internet, I've discovered [[https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers|this silabs drivers]] and they worked fine: the error was gone. They worked
+well on Windows 10 64bits. {{ :aeromodelismo:cp210x_universal_windows_driver.zip |Here}} is copy of the drivers.
+For configurators (betaflight, cleanflight) the firmware I am using is "LUX2_RACE".