Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
aeromodelismo:jawbreakerdrone [2019/03/02 12:37] – [Parts] rlunaro | aeromodelismo:jawbreakerdrone [2019/10/22 20:30] – rlunaro |
---|
[[https://hobbyking.com/es_es/blheli-s-30a.html|4 power controllers]] | [[https://hobbyking.com/es_es/blheli-s-30a.html|4 power controllers]] |
| |
[[https://hobbyking.com/es_es/lux-racer-flight-controller.html|LUX flight controller]] | [[https://hobbyking.com/es_es/lux-racer-flight-controller.html|LUX flight controller]] [[https://cdn-global-hk.hobbyking.com/media/file/33491594X50800X27.pdf|manual here]]{{ :aeromodelismo:33491594x50800x27.pdf |and here}} |
| |
[[https://hobbyking.com/es_es/tbs-triumph-sma-2pcs.html|Antennae]] | [[https://hobbyking.com/es_es/tbs-triumph-sma-2pcs.html|Antennae]] |
| |
[[http://www.banggood.com/1PCS-PandaRC-MMCX-to-SMARP-SMA-Female-Adapter-Connector-Cable-70mm-p-1184377.html?rmmds=cart_middle_products|antennae adapter cable]] | [[http://www.banggood.com/1PCS-PandaRC-MMCX-to-SMARP-SMA-Female-Adapter-Connector-Cable-70mm-p-1184377.html?rmmds=cart_middle_products|antennae adapter cable]] |
| |
| [[#|Receiver: Frsky XSR]] [[https://www.frsky-rc.com/wp-content/uploads/Downloads/Manual/XSR-Manual.pdf|manual here]] {{ :aeromodelismo:xsr-manual.pdf |and here}}. Obviously, this is only if your transmitter is FRSKY. |
| |
| |
| ===== Lux racer ===== |
| |
| For the firmware update and configuration, I've tried the zadig drivers that describes the manual of the |
| board, but I didn't achieve a good configuration. It appears "error connecting serial port". |
| |
| Searching on internet, I've discovered [[https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers|this silabs drivers]] and they worked fine: the error was gone. They worked |
| well on Windows 10 64bits. {{ :aeromodelismo:cp210x_universal_windows_driver.zip |Here}} is copy of the drivers. |
| |
| |
| For configurators (betaflight, cleanflight) the firmware I am using is "LUX2_RACE". |
| |
| |
| |
| |